This Kit includes a tiny Edison fits nicely onto a breakout board – sort of like a tiny IoT sparrow into a very small nest, so you can expose the native 1.8 V I/O of the Edison.
And it is for non-Arduino users. This breakout board has a minimalistic set of features and is slightly larger than the Edison module.
Dimensions: 61mm x 29mm x 12mm
• Uses a 22nm Intel® SoC that includes a dual core, dual threaded Intel® Atom™ CPU at 500MHz and a 32-bit Intel® Quark™ microcontroller at 100 MHz. It supports 40 GPIOs and includes 1GB LPDDR3, 4 GB EMMC, and dual-band WiFi and BTLE on a module slightly larger than a postage stamp.
• The Intel Edison module will initially support development with Arduino* and C/C++, followed by Node.JS, Python, RTOS, and Visual Programming support in the near future.
• It includes a device-to-device and device-to-cloud connectivity framework to enable cross-device communication and a cloud-based, multi-tenant, time-series analytics service.
• The breakout board has exposes native 1.8V I/O of edison module. And 0.1” grid I/O array of through-hole solder points. USB OTG with USB Micro Type-AB connector, USB OTG power switch. Battery Charge, USB to device UART bridge with USB Micro Type-B connector, DC power supply jack (7V – 15V DC input).
|Form factor||Board with 70-pin connector|
|Dimensions||61mm x 29mm x 12mm|
|Operating temperature||0 to 40 degC|
|Connector||Hirose DF40 Series
(1.5mm, 2.0mm, or 3.0mm stack height)
|Max Memory size||4GB|
|Memory type||DDR3, Nand Flash|
|Physical add. Ext.||32-bit|
|# of DIMMs||0|
|ECC Memory supported:||NO|
|Total of 40 GPIOs which can be configured as:|
|SD Card||1 Interface|
|SPI||1 Controller with 2 chip selects|
|GPIO||Additional 12 (with 4 capable of PWM)|
|USB 2.0||1 OTG Controller|
|Clock Output||32 KHz, 19.2 MHz|
|Major Edison Components|
|SoC||22nm Intel SoC includes: a dual core, dual threaded Intel Atom CPU at 500MHz, and a 32-bit Intel Quark microcontroller at 100 MHz|
|RAM||1 GB LPDDR3 POP memory|
|Flash Storage||4 GB eMMC|
|WiFi||Broadcom 43340 802.11 a/b/g/n|
|Dual-band (2.4 and 5 GHz)|
|On board antenna or external antenna SKU configurations|
|Input||3.3V – 4.5V|
|Output||100ma @3.3V and 100ma @ 1.8V|
|Power||Standby (No radios): 13mW|
|Standby (BT 4.0): 21.5mW|
|Standby (WiFi): 35 mW|
|Firmware + Software|
|CPU OS||Yocto Linux v1.6|
|Development Environments||Arduino IDE|
|Eclipse supporting: C, C++ & Python|
|Intel XDK supporting: Node.JS & HTML5|
|Development Environments||MCU SDK and IDE|